How Do I Use It? | How Do I Install It?
Sign Up! | Product Guide | F.A.Q. | Troubleshooting
Install Details | Launch Details | Advanced Options

• When trying to connect to the BrowseBlast Service, I get the error message, "BrowseBlast Web Accelerator cannot connect to the BrowseBlast Service..."
  
  
• When attempting to connect to the BrowseBlast Service, I receive the error, "The BrowseBlast Service does not allow connections from your current IP address..."
  
  
• When attempting to connect to the BrowseBlast Service, I receive the error, "Your Username and/or Password were not accepted by the BrowseBlast Service..."
  
  
• When attempting to connect to the BrowseBlast Service, I receive the error, "The BrowseBlast Service could not be started due to an authentication timeout ..."
  
  
• I receive the error, "BrowseBlast Web Accelerator cannot be started due to an internal error ..."
  
  
• I receive the error, "BrowseBlast Web Accelerator was unable to load the sdicore.dll library ..."

1. Check that you have successfully connected to your ISP in your usual manner (e.g. Did your dial-up connection successfully connect to your ISP?). This step is independent of whether or not you launch BrowseBlast Web Accelerator.
2. Ensure that the ISP that you are connected to is, in fact, the one that supplied you with the BrowseBlast Web Accelerator software and connection information. In most cases, you cannot connect to another ISP and use the same BrowseBlast Web Accelerator connection settings.
3. Verify that the Connection information located in the Settings dialog is the same as that provided to you by your ISP.
4. If you are running firewall software, make sure that a firewall rule is present that allows access to the Remote Server Port (located in the Settings dialog)
5. Try uninstalling the BrowseBlast Web Accelerator (Control Panel-->Add/Remove Programs and select BrowseBlast Web Accelerator) then re-install it.
6. Contact Customer Service (888 - 270 7985) to verify that the BrowseBlast Service is up and running.

Back to Top

Back to Top

Back to Top

1. Ensure that the authentication information provided to you upon sign-up has been keyed in correctly.
2. Try reconnecting to your Internet service.

Back to Top

1. Try restarting your machine and launching BrowseBlast Web Accelerator.
2. If the problem persists contact Customer Service (888 - 270 7985).

Back to Top

1. The likely cause of this is that you accidentally deleted a file or resource required by the BrowseBlast Web Accelerator. Fully uninstall and then re-install the BrowseBlast Web Accelerator.

Back to Top